Introduction to the performance and characteristics of Automatic A4 paper cutting and wrapping machine

Performance and characteristics of Automatic A4 paper cutting and wrapping machine:

1. Automatic A4 paper cutting and wrapping machine adopts PLC and touch screen control, magnetic powder clutch type tension control, and center winding method.

2. The host adopts frequency conversion speed regulation, can automatically count meters, alarm and stop, and all tension numbers are displayed on the touch screen.

3. The unwinding adopts photoelectric automatic correction (or ultrasonic correction) to correct the neat edges of the paper, so that irregular materials can be slit normally.

4. Round knife (or straight knife) slitting, automatic waste edge discharge device.

5. Manual (or pneumatic) loading. The unwinding shaft is equipped with a taper sleeve type inflatable shaft (3" or 6").

6. Rewinding adopts A and B axis (inflatable type).

In order to make the Automatic A4 paper cutting and wrapping machine work normally and cut out high-quality finished products, the condition of each part of the machine should be checked from time to time and lubrication points should be added.

Operating environment of Automatic A4 paper cutting and wrapping machine:

The quality of the use environment directly affects the characteristics and service life of the Automatic A4 paper cutting and wrapping machine and its parts. The environment where the equipment is installed should pay attention to the following matters.

1. Good indoor ventilation.

2. Ambient temperature -10℃+40℃.

3. Try to avoid high temperature and humidity, the humidity is less than 90%RH, and no rain drops.

4. Avoid direct sunlight.

5. No flammable, corrosive gas and liquid.

6. The installation foundation is fixed without vibration.

7. No electromagnetic interference, far away from the source of interference.