Notes on using the Automatic Box Strapping Machine

    You should pay attention to its common problems during the use of any equipment, and the Automatic Box Strapping Machine is no exception. The so-called Automatic Box Strapping Machine mostly refers to the baler, because the consumables used by the baler are the straps. I will share with you below. Instructions for using the Automatic Box Strapping Machine.

    Before using the Automatic Box Strapping Machine, you must check whether the photocell of the baler is in good condition, whether the reflector is aligned and whether there is dust on it. If it is not aligned, put it in the correct position and remove the dust on it. Whether the screws and nuts of each component are loose, they should be tightened in time. If there is a phenomenon of missing nails and caps, the repair personnel must be notified to deal with them in time. The above are the most basic common sense of using the baler. Axiomtek will not introduce too much here. What Axiomtek would like to share with you is what should be paid attention to when using the Automatic Box Strapping Machine from a professional point of view? As a professional manufacturer of Automatic Box Strapping Machine, Axiomtek reminds you that lubrication is very important during the use of the baler, especially the lubrication of the knife set. Many users do not know that the knife needs to be lubricated. In fact, the knife of the baler is different from The packing tape is cut by friction between the knives, so the knives must be lubricated.
    The above is what to pay attention to when using the Automatic Box Strapping Machine, I hope it will be helpful to your use.